Skeinforge Chamber
From Wiki
Some filaments warp too much and to prevent this you have to print the object in a temperature regulated chamber or on a temperature regulated bed. The chamber tool allows you to control the bed and chamber temperature.
NOTE: Not supported by RapMan
Contents |
Operation
The default 'Activate Chamber' checkbox is on. When it is on, chamber will add the temperature commands, when it is off nothing will be done.
Settings
Bed Temperature
Default is 60C.
Defines the print_bed temperature in Celcius by adding an M140 command.
Chamber Temperature
Default is 30C.
Defines the chamber temperature in Celcius by adding an M141 command.
Holding Force
Default is zero.
Defines the holding pressure of a mechanism, like a vacuum table or electromagnet, to hold the bed surface or object, by adding an M142 command. The holding pressure is in bar. For hardware which only has on/off holding, when the holding pressure is zero, turn off holding, when the holding pressure is greater than zero, turn on holding.
Heated Beds
Bothacker
Bothacker made a resistor heated aluminum plate and wrote the article 'Heated Build Platform.'
Domingo
Domingo made a heated copper build plate and wrote the article 'Heated Base Plate.'
Jmil
Jmil made a heated build stage and wrote the articles 'Handling Hot Build Surfaces' and 'Heated Build Stage Success.'
Kulitorum
Kulitorum made a heated bed. It is a 5mm Alu sheet with a pattern laid out in kapton tape. The wire is a 0.6mm2 Konstantin wire and it's held in place by small pieces of kapton tape. He wrote the description 'Adding a Heated Bed.'
Metalab
The Metalab folks made a heated base, with the descriptions 'Metalab Heated Base Search.'
Prusajr
Prusajr made a resistive wire heated plexiglass plate and wrote the article 'Look Ma! No Warping Heated Reprap Print Bed.'
Pumpernickel2
Pumpernickel2 made a resistor heated aluminum plate pictured below.
Zaggo
Zaggo at Pleasant Software made a resistor heated aluminum plate and wrote the articles 'Raftless' and 'Canned Heat.'
