User Submitted Notes on the BfB3000 Operation Manual

From Wiki

This page contains notes submitted by users about the operations manual

Contents 1 Get to know BFB 3000 3 2 BFB 3000 parts list 4 3 Un-packing and assembling BFB3000 5 - 13 4 Fitting and loading the filament 14 - 16 5 Overview 17 6 First power up 18 7 Control interface 19 - 24 8 The co-ordinate system 25 9 Manual move - checking it all moves 26 10 Levelling the bed 27 – 29 11 Levelling the nozzles (dual head only) 30 - 32 12 Extruder tool setup 33 - 35 13 Extruder first run 36 - 38 14 Setting the Z height overview 39 15 Initial Z height set 40 - 43 16 SD Card 44 17 Run file 45 - 46 18 Calibrate the Z height 47 - 49 19 Calibrate x and y offsets (double head only) 50 – 52 20 Firmware 53 21 First print 54 22 Fine tuning your print 55 - 58 23 Maintenance 59 24 Appendix 60

Get to know BFB 3000 3

BFB 3000 parts list 4

Un-packing and assembling BFB3000 5 - 13

Fitting and loading the filament 14 - 16

Overview 17

First power up 18

Control interface 19 - 24

The co-ordinate system 25

Manual move - checking it all moves 26

Levelling the bed 27 – 29

Levelling the nozzles (dual head only) 30 - 32

Extruder tool setup 33 - 35

Extruder first run 36 - 38

Setting the Z height overview 39

Initial Z height set 40 - 43

SD Card 44

Run file 45 - 46

Calibrate the Z height 47 - 49

Page 47 Quote... Go to our web site and copy the file “TR3000.bfb” onto the SD card... the operations manual is a bit out of date you should use ....

• 'RaftP1bfb3000.bfb' - 3D 3000 with a single or double extruder using 'PLA' Polymer.
• 'RaftA1bfb3000.bfb' - 3D 3000 with a single or double extruder using 'ABS' Polymer

These can be found in BfBRafts.zip in the print files section of the BfB downloads page or click hereBfBRafts

Calibrate x and y offsets (double head only) 50 – 52

Firmware 53

First print 54

Fine tuning your print 55 - 58

Maintenance 59

Appendix 60